CAT 5e patch cable
Design and build a fully compliant end to end CAT 5e shielded network with the DataMax screen twisted pair (ScTP) patch cable, which meets all requirements of TIA/ EIA 568B for ScTP enhanced CAT 5e.
Constructed with 26 AWG stranded copper, the patch cable is insulated with low loss foamed dielectric, and shielded with an overall aluminum/polyester tape and tinned copper drain wire. The twisted pairs have stable 100 Ohm nominal impedance and a low 13.0 pF/ft. mutual capacitance. When terminated with CAT 5e shielded (screened) modular plugs, the cords fully comply with cordage return loss and crosstalk standards. Quabbin Wire & Cable
Labeling software
Improve identification of cabling system components with professional labeling software. The Windows-based software is preloaded with templates for labeling connectors, patch panels, cable applications and other components. Port and cable spacing is prepositioned, enabling users to enter their sequences and print. 8.5″ x 11″ sheets feed through printers easily; a number of the labels are in TIA/ EIA 606A compliant colors. Precut, perforated sheets feature adhesive capabilities specifically designed for communications equipment. Tyco Electronics
Patch cords
New Category 5, Category 5e and HiPerlink 6 patch cords are designed to minimize crosstalk and maintain signal integrity. Available in a variety of colors, the patch cords are engineered to achieve excellent performance levels with increased bandwidth and superior return loss performance. The HiPerlink 6 and CAT 5e cords are equipped with removable boots, providing additional strain relief, while maintaining bend radius. The boots also fit in high density applications, such as hubs, switches and routers. The CAT 5 cords do not have boots, but are also designed for strain relief. Cords are available in lengths of 3′, 5′, 7′, 10′ and 14′; standard blue is available in additional lengths ICC
Fiber connector
No epoxy or polishing is required with the UniCam LC multimode and single mode connector. The connector is designed like a pigtail, incorporating a fiber stub fully bonded into a ceramic ferrule and factory polished. The opposite field fiber end is cleaved and placed into a patented alignment of the mechanical splice. The field fiber is mated to the fiber stub, and the connector is cammed to complete the termination. The field fiber and fiber stub are fully protected from environmental factors. Designed and tested for compliance with FOCIS 10 and ANSI/TIA/EIA 568, it is ideal for higher performance networks where more density is required. It is also available in SC-, FC-, ST-compatible and MT-RJ styles.Corning Cable Systems